MOTOR DRIVER Controls one stepper motor with four bit microstepping Programmable Coil current up to 800 mA Operating voltage range 8V...29V Fixed frequency PWM current control with automatic selection of fast and slow decay mode Full step frequencies up to 1kHz High temperature, open circuit, short, over-current and under-voltage diagnostics
MOTOR CONTROLLER Internal 16-bit wide position counter Configurable speed and acceleration settings Built-in ramp generator for autonomous positioning and speed control On-the-fly alteration of target position Reference switch input available for read out Two wire interface (IC Communication) Transfer rates up to 350 kbps Diagnostics and status information as well as motion parameters accessible Field-programmable node addresses (32)
Lin Engineering can design and manufactures stepper motors specific to your environmental, mechanical, and dimensional requirements for step motors.click on image to view our options
Shaft
..Modifications
Custom
..Housings
High
..Temperature/
..Vacuum
..Environments
Added
..Value
..Assemblies
Lead Wires
..& Cables
General
..Options
Lin Engineering step motors are available with either 2-coil Bipolar, or 4-coil Unipolar windings. Bipolar motors have 4 leads, while unipolar motors have 6 leads. Additionally, some stepper motors are designed with 8 leads, so they may be connected in a variety of ways. Click here to view our connection instruction
C Communication) 
